Aver SD1306 quick guide Manuel d'utilisateur

SD1306 Speed Dome IP Camera Quick User Guide

8 II. Monitor Setting 1. Right-click on the desktop. Select “ Properties” 2. Change “Color quality” to “Highest (32-bit)”.

9 III. IP Assignment There are two ways to find IP Camera:  Finding IP Camer

10 3. Click “Setup” button. 4. Click “Add IPCam” button. 5. Select “IP Camera” item.

11 6. Enter the IP Camera’s ID and Password (default is admin/admin) and clic

12 Finding IP Camera by using “AVer IPCam Utility” 1. Use the software, “AVer IPCam Utility” to assign the IP address of the IP camera. The software

13 5. The IE browser will open and direct you to IP camera login page. This r

14 Using NON-DHCP Server/Router Network In Non-DHCP server/router network, the static IP address must be assigned to the device each time when adding

15 IP camera IP addresses: A quick way to access remote monitoring is to dou

16 IV. Connecting the IP Camera Launch the Internet Explorer browser, type the IP address of the IP camera in the address field. It will show the fol

17 COPYRIGHT © 2015 AVer Information Inc. All rights reserved. All rights of this object belong to AVer Information Inc. Reproduced or transmitted i

Table of Contents I. Camera Introduction ... 1 1. Package Con

18 Limited Warranty AVer Information, Inc. (“AVer”) warrants that the applicable product (“Product”) substantially conforms to AVer’s documentation fo

19 Governing Law and Your Rights This warranty gives you specific legal rights;

1 Before Installation Before installation, please be sure to read this quick installation guide and user’s manual carefully to complete the installat

2 2. Hardware Installation 1. Install SD1306 with wall mount Step 1: Install the base on the wall. Step 2: Install the camera with wall mount pipe

3 3. Instruction to remove cameral module from camera housing and install cab

4 4. I/O Configuration  I/O Connection a. Please connect the G & AO pin to the external relay (buzzer) device. b. Please connect the G &

5 If you select "N.C" in "Input sensor setting", when exte

6 2.1 Factory Default 1. To recover the default IP address and password, please follow the following steps. 2. Remove power and Ethernet cable. 3

7 3. SD card Compatibility List SD1306 is compliant with microSD/SDHC car