System Controller Pro Quick Installation Guide
8 8. Click OK to complete the setting. IV. Select the Operation Mode on System Controller For System Controller to operate the DVR system normall
9 QUICK USER GUIDE 3. In Mode setup screen, press button to switch the mode to USB DVR mode. 4. Press button to confirm. To cancel the sel
10 3. In Mode setup screen, press button to switch the mode to 485 DVR mode. 4. Press button to confirm. To cancel the selection, press
11 QUICK USER GUIDE 2. In System Controller setting screen, select . 3. In Mode screen, select the . If the current mode is USB-CMS mode alrea
12 Switching to 485 CMS Mode When the System Controller is connecting with CMS server through the 485 port, the System Controller mode s
13 QUICK USER GUIDE 4. Press button to confirm. To cancel the selection, press button. When the “Complete” message appears on the LCD screen
14 VI. Operating the LCD Menu Main Menu On the LCD screen, each function is corresponding to the button on the panel of the System
15 QUICK USER GUIDE To go back to the main menu, press the TOP MENU button. Press the BACK button will go back to the previous screen. Switchi
16 VII. To Playback the Recorded File on DVR server To playback the recorded file on surveillance screen. 1. Press button to switch to playback m
17 QUICK USER GUIDE 2. And, the DVR selection dialog will show up on surveillance screen. Select the DVR server and click OK. User can use mouse o
COPYRIGHT COPYRIGHT © 2011 AVer Information Inc. All rights reserved. No part of this document may be reproduced or transmitted in any form, or by
18 5. After selected the time and date to playback, the CMS system will start to playback. i The playback UI will be a little different due to the
19 QUICK USER GUIDE 9. Press button can capture screen image and save it. i The and function button doesn’t support for SEB5108H/5116H serie
20 Tilt Move the joystick to up or down. Zoom in/out Rotate the joystick to the clockwise side to zoom in and counterclockwise to zoom out.
P/N: 300AC2CSADNG July 2011
1 QUICK USER GUIDE I. Hardware Introduction Left Side i System Controller doesn’t support audio input/output port for SEB5108H/5116H se
2 Rear Side i System Controller for SEB5008H/5116H series and EH5108H/5216H series doesn’t support RS485 port connection. Function Descript
3 QUICK USER GUIDE II. Hardware Installation USB port connection The following is an example of System controller installation for NV, SA, IWH Touc
4 1. Cut the 4 single core wires. 2. Using the screwdriver to press down the orange tenon and insert the single core wire into the pin hole of the
5 QUICK USER GUIDE 5. Connect the RS232 cable to the RS232 port of the RS485 to RS232 converter. 6. Connect another side of RS232 cable to the
6 DVR server site System Controller site R+ T+ 1 R- T- 2 T+ R+ 3 T- R- 4 4. On the DVR server, using the screwdriver to press down the orange teno
7 QUICK USER GUIDE III. Enabling the System Controller i SEB5108H/5116H series and EH5108H/5216H series DVR will detect and install System Controll
Commentaires sur ces manuels