FV2006-1 Mini Vantal Dome IP Camera Quick User Guide
8 III. IP Assignment There are two ways to find IP Cameras: Finding IP Camera by using the “NXU Lite recording software” Finding IP Camera by u
9 3. Click the “Setup” button. 4. Click the “Add IPCam” button. 5. Selec
10 6. Enter IP Camera’s ID and Password (default is admin/admin) and click “Auto Search” to find camera. 7. In the Search Result window, click th
11 Finding IP Camera by using “AVer IPCam Utility” 1. Use the software, “AVer
12 5. The IE browser will open and direct you to the IP camera login page. This requires IPViewer.ocx to run. If the IE ActiveX warning message appe
13 Using NON-DHCP Server/Router Network In Non-DHCP server/router network, the
14 IP camera IP addresses: A quick way to access remote monitoring is to double-click on a selected IP camera in “Camera Name list” in AVer IPCam U
15 IV. Connecting the IP Camera Launch the Internet Explorer browser, type the
16 FCC NOTICE (Class A) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
17 THE MARK OF CROSSED-OUT WHEELED BIN INDICATES THAT THIS PRODUCT MUST NOT BE
Table of Contents I. Camera Introduction ... 1 1. P
18 Limitation of Liability In no event shall aver be liable for indirect, incidental, special, exemplary, punitive, or consequential damages of any na
1 Before Installation Before installation, please be sure to read this quick installation guide and user’s manual carefully to complete the installat
2 2. Hardware Installation 1. Set the camera Locate cable from bottom i. Use three screws to lock the base of camera on the ceiling or the wall.
3 Locate cable from side a. Open the conversion ring package in accessory.
4 2. When removing the dome cover, you can see the Micro SD card slot and the reset button. 3. I/O Interface I/O Connection a. Please connect the
5 2.1 Factory Default 1. To recover the default IP address and password, plea
6 3. SD card Compatibility List FV2006-1 is compliant with microSD/SDHC card and to ensure recording quality, and please use memory card
7 II. Monitor Setting 1. Right-click on the desktop. Select “ Properties” 2. Change “Color quality” to “Highest (32-bit)”.
Commentaires sur ces manuels